This paper presents a shadow signal generator that produces square and triangular waveforms. The oscillator frequency can be changed using an external circuit (shadow oscillator). This method will make the conversion speed better than the conventional oscillators. The technique is based on utilizing an external circuit to modify the comparator’s tripping point. The circuit is built using widely available commercial integrated circuits, 1% accurate resistors, and DC supplies with a ±5V voltage. The recommended setup is suitable for instrumentation where the oscillation frequency is directly proportional to the variation in the resistance of the sensor. The functionality of the proposed design was confirmed by experimentation and simulation. The oscillation’s frequency can be changed to be nearly 10 times greater than its starting value, according to the results.